\HELP\WINME\WINME.TXT

                        NETGEAR FA330/FA331 PCI Adapter
                        -------------------------------
                 Driver Installation for Microsoft Windows Me
                 --------------------------------------------

  Getting Started
  ---------------
  Microsoft Windows Me does not come bundled with the driver for the
  NETGEAR FA330/FA331 PCI Adapter.  You must go through the following
  procedure to install the device driver into the Windows Me system
  for the adapter to function properly.

  The Windows Me CD is needed to complete this installation.

  Windows Me Installation Procedure
  ---------------------------------------
  It is recommended that you complete the Windows Me installation without
  the adapter card in the system.

  1.  Shut down the computer and install the NETGEAR FA330/FA331 PCI Adapter
      into the system.

  2.  Start your Windows Me system normally.

      Upon power up, the system will pop-up the "Add New Hardware Wizard"
      window and indicate to you that a new PCI Ethernet Controller has
      been found.

  3.  Insert the Driver and Diagnostics disk.

  4.  Select the "Automatic search for a better driver(Recommended)"
      and click on "Next".

      The next window should indicate that the "NETGEAR FA330/FA331 PCI
      Adapter" has been found.

  5.  The system starts copying files.
      Click on "Finish" when Windows has finished installing the new hardware
      device.

  6.  Click on "Yes" when asked if you want to restart the system.

  7.  Remove the driver disk and the Windows Me CD-ROM when the system
      reboots.

  Advanced Setup
  --------------
  The FA33X driver configures the adapter card to operate in autosensing
  mode by default.  In this mode, the card automatically selects the most
  appropriate operating speed and duplex mode.  There might be instances
  when you need to configure the adapter card to operate at a particular
  speed and duplex mode.  The following procedure guides you into the
  Windows Me system for this setting.

  1.  In Control Panel, open "Network".

  2.  Click on the "NETGEAR FA330/FA331 PCI Adapter" selection. Then, click
      on the "Properties" button.

  3.  Click on the "Advanced" memu tab in the FA330/FA331 adapter card window.

  4.  Click on the "Network Media" property selection.

  5.  The "Network Media" windows will show the following possible selections:

        Auto Sense
        10BaseT                        (Ethernet)
        10BaseT Full duplex
        100BaseTX                      (Fast Ethernet)
        100BaseTX Full duplex

      Choose the appropriate setting as needed.

